- UID
- 262041
- 经验
- 22 点
- 威望
- 15 点
- 金钱
- 11 金轮胎
- 积分
- 505
- 注册时间
- 2010-1-2
- 在线时间
- 753 小时
- 最后登录
- 2022-9-21
- 帖子
- 141
- 主题
- 11
- 精华
- 0
e族天使
注册2010-1-2
|
说明书上的设置过程。黑色为1号钥匙,灰色为2号钥匙
To set the memory buttons follow this procedure:
1. Turn the ignition key to the ON position.
点火开关到ON的位置
2. Press the memory button “1” if you are setting the
memory for driver one or number “2” if you are setting
the memory for driver two.
按下1或者2按钮(根据你要设置的钥匙而定)
3. Adjust the seat, recliner, and driver’s outside rear view
mirrors to the desired position.
调整座椅、靠背、后视镜到需要的位置
4. Set the radio station presets as you desire (up to 10AM
and 10 FM station settings).
设置收音机频道(最多10个FM,10个AM)
5. Press and release the SET button. An indicator light on
the set switch will flash, telling you that you are in the set
memory mode.
按下、释放SET按钮。SET按钮上的指示灯闪烁,表明进入了记忆模式
6. Press and release button number “1” or number “2” on
the driver’s door, depending on which transmitter you’re
using. The flashing indicator light on the set switch will
go out telling you that the driver memory has been set.
按下、释放1或者2按钮,视你要选择的钥匙而定。SET按钮上的指示灯闪烁,表明记忆设置成功。 |
|